[Clam-devel] IMPORTANT: more changes to build system

Hernán Ordiales h at ordia.com.ar
Wed May 23 10:12:41 PDT 2007

On 5/23/07, Pau Arumi <parumi at iua.upf.edu> wrote:
> this issue probably shows up now just because now on every "scons
> option=value" invocaton, the configure step is automatically
> called (which, btw, i a *very* convenient change).
> i tried this here and got the same error. looking at config.log
> file i saw that xercesc check was the first one using g++
> (instead of gcc) and, thus, was using "distcc g++". the error was
> simple: could not found "distcc". then i installed distcc and all
> configure went fine. so, hernan, check if this is also your case.

yes, was that. I forgot that i had installed from scratch here... :-)
nice tip the config.log

> so now the TODO is: adding a custom distcc checking. i've filled
> a bug for that (#262). patches are welcomed!

ok, i'll take a look on that, where are the depencies check on scons?
another py file?

GnuPG: 0xEE8A3FE9

More information about the clam-devel mailing list